A camlock adaptor bridges the gap between two connections that do not fit together directly. This section covers reducers between two camlock sizes, transitions to IBC containers and adaptors to other coupling systems. NexaParts supplies them in aluminium, stainless steel 316, brass and polypropylene, from DN13 to DN200. A camlock adaptor is by definition the narrowest or weakest point in a line and therefore deserves the same attention on material and pressure as the couplings themselves. Order it on three details: the two connections it has to join, and the material.
A reducer joins a DN100 to a DN50, for example, and saves you replacing a whole hose fleet when bores no longer match. That is common in operations that have renewed their hoses in stages over several years. Do allow for the pressure drop, though: a reducer narrows the bore and raises fluid velocity, which shows up as less pressure at the end of the line. Over one size step the effect is modest; over two steps or more it becomes clearly noticeable. Place a camlock adaptor as late in the circuit as possible and never chain several in series, because with laden or viscous media an abrupt restriction also raises the risk of blockage.
An IBC container comes with an S60x6 thread on the discharge valve as standard. An adaptor converts that to a camlock connection so you can fill or empty with an ordinary hose. This is one of the most requested transitions in our range, available with either a male or a female camlock part on the opposite side, so you can build the container into a line that already runs on camlock without changing a single hose. For chemicals, watch the material: polypropylene is cheap and does not corrode, but stainless steel 316 is the better choice once solvents or acids are involved. Note too that an IBC itself rarely takes more than a few bar, so a camlock adaptor rated at 16 bar does not raise the limit of the container it is screwed into. Check the seal on the S60x6 side as well, because that ring is chosen on the medium exactly like the camlock ring behind it.
A camlock adaptor to Guillemin, Storz or GEKA makes it possible to join equipment that was never designed to fit. That matters for operations working with several suppliers, for hire fleets and for cross-border use, where the standard changes at the border while the equipment does not. Guillemin is the French standard and common in fire services and agriculture, Storz is the German fire service standard, and GEKA is widespread on water and compressed air in light industry. A camlock adaptor to any of these saves you from duplicating an entire hose fleet for the sake of one interface. Always check the material and working pressure of the transition piece, which additionally introduces a second gasket into the line. That gasket must be chosen on the medium just as carefully as the camlock ring, and in practice it is the part that leaks first.
On any transition, the lower of the two stated working pressures sets the limit for the whole assembly. A coupling rated at 16 bar on an adaptor rated at 10 bar does not give you a 16 bar installation, and in industrial use that is not a detail. Always check the figure for the weakest component.
See the full range on our camlock couplings page.
Didn't find the right Camlock Adaptors?
Fill in the form below, and we'll assist you further!
Curious about our blog? Check out all our items here!
Contact us here