The Guillemin gasket is a flat sealing ring seated in the face of the coupling half. It is the only wearing part in the whole system: the body lasts years, the gasket considerably less. When a coupling weeps, the gasket is almost always the cause and not the coupling itself. NexaParts supplies the Guillemin gasket from DN20 to DN150 in EPDM, NBR, FKM, PTFE and silicone, with FDA versions for food contact, to fit couplings made to NF E 29-572 and EN 14420-8. You can order singly or by the set, so you can build a spares holding for every size in your fleet. Two figures are needed: the nominal bore and the compound.
Make the choice on the medium and the temperature, never on price. NBR suits oils, fuels and hydrocarbons but degrades quickly under steam. EPDM is the reverse: excellent on water, aqueous solutions, steam and many cleaning agents, but attacked by mineral oils. FKM covers high temperatures, solvents and many aggressive chemicals. PTFE resists almost everything, concentrated acids included, at the cost of compliance, which calls for an evenly loaded face. Silicone is reserved for food applications and wide temperature swings. A wrongly chosen Guillemin gasket swells, hardens or splits within weeks, while the right one lasts the full maintenance interval. If you are unsure of the medium, send us the composition and the working temperature and we will check the choice with you.
Four signs are visible to the naked eye. The gasket has hardened and no longer springs back when you press it with a finger. The surface shows fine cracks, often radiating around the contact zone. The gasket has swollen and stands slightly proud of its groove, a sign of chemical incompatibility. Or it carries a permanent, flattened and shiny impression left by clamping. In all four cases replace it without waiting for the leak: a film at the face eventually causes corrosion under the gasket and damages the groove itself, turning a spare worth a few euros into replacement of the entire coupling half.
Replacement is done by hand, without tools: the old ring lifts out of the groove and the new one presses into place. Take the opportunity to clean the groove and check that no debris remains. Keep one Guillemin gasket set per size in use and two sets for the bores you strip down often. On a scheduled inspection, replacing preventively always costs less than a failure in the field.
A gasket is size specific: a DN65 will not seat in a DN80 groove. Check the DN marking on the coupling before ordering a replacement Guillemin gasket. See the full range on our Guillemin couplings page.
Didn't find the right Guillemin Gaskets?
Fill in the form below, and we'll assist you further!
Curious about our blog? Check out all our items here!
Contact us here